MOTM

At 2:58 PM -0500 2002/01/09, revtor@... wrote:
>Also, I had my 320 patched into the "delay"
>cv input.  yes the 320 is+/-5v and the TM says that this input takes from
>0-7.5v  I hadnt read this until after my little problem arose.  Patching them
>together led to my delay not making any more delayed signal until I powered
>it down and up again.  It worked for a second or two then as the 320 reached
>a certain level the TM "thumped" and no more delayed signal.  but upon
>turning it off and on again, it worked fine... Im assuming this has to do
>with the bipolar nature of the 320?  Just wondering if this is normal, and
>wanting confirmation that everything is A-OK!!!!
>

I haven't built my TM yet, but I've had a quick look at the schemo 
and there's nothing built in to keep -ve voltages out. Since the spec 
says to use 0-7.5 volts, I'd try putting a diode across the CV input 
to keep -ve voltages out. Take a look at how Paul does this with the 
800 GATE input.