MOTM

If I use the a dual OTA, triange-based VCO, then I can get SAW for a minimal
effort.
So, I'm thinking these lines:

<<the observant will note the panel is the same as the MOTM-800! That's part
of the attraction: I just change silkscreens>>

COARSE
FINE
+/- FM
WAVESHAPE   <<between SQUARE and SAW, this is a fader pot>>

jacks are

1V/Oct     FM
TRI           VAR

I'm thinking this will fit (barely!) on the MOTM-800 "form-factor" pcb.
Still looking like $159 kit, $80
less than a '300.

Even though this VCO has no SYNC, you *can* use it to drive SYNC into a
MOTM-300.
And I'm jealous of Joe Ps. MOTM, too!

Last little thing: hopefully the new end panels will be ready by Friday.
Wait until the
word is out to order.

Paul S.