MOTM

----- Original Message -----
From: <dgsaa@...>
I'm building an MOTM-ized Dark Star, and I need suggestions on
redoing the jack and pot wiring for the Stooge panel I've ordered.
The Blacet instructions call for the jacks to be all wired together
to a common bare ground wire, and I think changes will be
needed for the pots as well.  Does anyone know of a
resource/summary of the wiring changes for this module?  Other
sources of help?
There may be instructions to this effect included with the Stooge
panel, but since I don't have it yet I'm not sure.
------
Larry Hendry writes:

David,
    There are no specific instructions with the Dark Star panel.  Some level
of DIY ability is assumed and required for these conversions from the Blacet
frac rack to MOTM format.  The pots are wired off board.  But, essentially,
they connect the same.  Electrically, there is no need to change from the
Blacet design.  However, the panels are made to support certain circuit
modifications that are detailed on Dave Bradley's web site:
http://www.users.qwest.net/~daveb2/ds_mods.htm
I personally do not own a Dark Star.  Dave Bradley is the resident Dark Star
expert.

Larry Hendry