MOTM

The fit is can be extremely tight. I've had it happen on a few kits that
I've built too. My solution is to thread the pot into the hole. It will go
in pretty easily that way, and by the time you get to the base of the pot,
you'll cut "threads" into the paint inside the hole and then you'll just
naturally "strip" the threads.


Tony Karavidas
Encore Electronics

http://www.EncoreElectronics.com

Designers of "The best MIDI to CV converter on the planet." -Keyboard Oct.
1997


> -----Original Message-----
> From: John Broaddus [mailto:john@...]
> Sent: Saturday, May 19, 2001 4:19 PM
> To: MOTM List
> Subject: [motm] Question about MOTM-410 assembly
>
>
> Hello list,
>
> I'm new to the MOTM kits and am building my first module, the MOTM-410.  I
> am at the stage where the instructions say to mount the
> PCB/Bracket assembly
> to the front panel and I'm having a very hard time getting the pots to fit
> through the front panel holes.  Is this typical on this and/or other kits?
> I hate to force it too hard but since I haven't built any of these kits I
> am wondering if that's what I need to do.
>
> Any advice would be greatly appreciated!  Instead of contacting
> Paul at this
> time I thought I would try the list first.
>
> Thanks for any help!
>
> John Broaddus
>
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>
>