MOTM

I had to try it, it only works really subtly, kinda what I had expected.. 
just barely noticeable.. it does change up the shape nicely though as It 
should  (DUH)  Will the MOTM phaseshifter work on CV's as well?  As in, input 
a triangle LFO and out comes the same but phaseshifted 90 or 180 degrees?  Am 
I retarted?  NEW ! MOTM 340 Quad phase LFO.  selectable Sine/saw, four 
different phase outputs..
anyway.. I stumbled into the 'ol 300-->MOTM 120 (only #3 full on) gating an 
800 (for shapecontrol), 800+ output ---> LFO FM input. makes a nice 
stairstepping CV when tuned right.. a bit touchy but nice when you get it 
where you want it..
add raw LFO outs and LFO run through 820 outs to a few key places and space 
out..later,
~Steve
(now if we had VC panning!!!!)