yes it's tip positive. --- In korgpolyex@yahoogroups.com, Marcus Wilson <JB@...> wrote: > > check the polarity of the power plug, it must be tip positive > > if its tip negative, it will disconnect power from the battery and > apply inverted voltage to the input, theres a zener in there to offer > some protection so you > dont fry everything, but its not a good thing to keep juiced up with > incorrect polarity > > best regards, > > Marcus Wilson > > > On 25/08/2008, at 6:16 PM, Dennis wrote: > > > This poly 800 seems to function just fine on batteries but when a 9 > > vdc converter is plugged in it goes dead. I figured it was the jack > > and replaced it after desoldering the original and replacing it with a > > clone. Same problem. Any ideas would be greatly appreciated! > > > > Thanks! > > > > > > >
Message
Re: HELP! power supply causing pcb short
2008-08-26 by Dennis
