Re: Problems with Mac Classic II 7.0.1
2008-09-14 by hexafuzz
... Cant remember how to solve this behavior, but I have seen it before. You seem to be checking the right things, so I cant offer much: Remove any midi cables
Messages
Browse messages
Page 29 of 48 · 2353 messages matched
Problems with Mac Classic II 7.0.1
2008-09-14 by mrjdevries
Hey all, I ve just recently got a Mac Classic running 7.0.1 OS. (4mb ram) I ve previously been able to get my mac IIsi to talk to my Emulator II, but the
SV: [emulatorII-list] Re: So how do i transfer SD to my mac book 5300c
2008-09-12 by hexafuzz
... jaedoo Im not sure about 8.6 with SD as Ive never run anything higher than System 7.5.5. However downgrading to 7.01 is a bad idea for two reasons Ken:
SV: [emulatorII-list] Re: So how do i transfer SD to my mac book 5300c
2008-09-11 by Kenneth Abildgaard | OIIO
I am not sure it’s gonna be a problem. But you CAN download 7.0.1 for free at the Apple site if you’re ready to downgrade J Kenneth 12bit.com Fra:
Re: [emulatorII-list] Re: So how do i transfer SD to my mac book 5300c
2008-09-11 by J N.
Hey HEXAFUZZ Thanx My mac is running O.S. 8.6 is that gonna be problem,and if so any tips to get around the O.S. 8.6 ???? thanx again ... From:
Re: So how do i transfer SD to my mac book 5300c
2008-09-10 by hexafuzz
... Mac System 7.1 and later should be able to read PC (Dos) formatted floppies using PC Exchange (if not already on your Mac, PC Exchange is available in the
So how do i transfer SD to my mac book 5300c
2008-09-09 by J N.
Hello All I m wondering how can i swap a version of Sound Designer to my mac book 5300c after downloading it from a PC(windows XP) the MAC dosn t seem to
Re: [emulatorII-list] Re: Parts?
2008-09-04 by Jean-Bernard EMOND
... Haaa quel horreur des rappeurs ;)
Re: Parts?
2008-09-04 by elmbeatz
Hi! I added a link to FORAT ( http://www.forat.com/service/##SP1200 ) They also sell new backlights, but they seem to be yellow.
Re: Parts?
2008-09-03 by hexafuzz
... There are two sources for backlights listed in the group links section: http://launch.groups.yahoo.com/group/emulatorII-list/links
Parts?
2008-09-03 by mike1pa1
Hella all! Is is still possible to purchase the parts to replace the backlight on the EII. It is still working but is very pale. I have read up that this is
Re: One disk ? and HD ?
2008-09-02 by Doug Berg
... able ... Hello Kevin: Have same model and this seems to be typical symptom of these hard drives. I can assume when you power up unit the red l.e.d .
E II + , ON EBAY.
2008-09-01 by Cristea Eusebiu
Look, maybe somebody interested :
Re: One disk ? and HD ?
2008-08-29 by Heiko Mehring
Hello Kevin, welcome here. ... that the 5 1/4 drive really works, I beleive it does because I was able to format the floppy but need to validate it works
One disk ? and HD ?
2008-08-29 by Kevin Kelley
Hello I have an E2 + HD abd it boots but it sometimes takes several attempts to power it up and have the HD boot the OS any advice on how to fix this? I
Re: Emu II and Mac
2008-08-27 by esynthesist
Congratulations. The compatible Mac/EII combinations can be found in the Database section. But a simple Mac Classic running OS 7.5.3 should do the job. Don t
Emu II and Mac
2008-08-27 by Mike Dade
Hi I am now the proud owner of an Emulator Ii after many years searching.. Firstly, the OS disc must have been wiped so have one on order so that I can check
Re: absolute newbie here!!
2008-08-18 by Heiko Mehring
Hello Jason, welcome here. :-) ... You`ve got a device from the good old eighties. And so it is very cool to use it, like they have used in in the eighties.
Re: absolute newbie here!!
2008-08-18 by hexafuzz
... Congratulations Jason and welcome to the group. You will find everything needed to get you started (and more) in the groups file and links sections and by
Re: [emulatorII-list] Re: Supporters for Reverse Engineering needed
2008-08-17 by Cristea Eusebiu
Great idea. Will be much easier and the point here is also that we can use the actual tech. I really hope in that. Regs, Mike, Oslo, Norway. ... From: Dana
Re: Supporters for Reverse Engineering needed
2008-08-17 by Dana Fiorucci
Yes the Datex DTX200 looks like the best option. If you can get this worked out I would be interested in getting one of these to replace my lower drive. I
absolute newbie here!!
2008-08-17 by Jason Herbert
Hi all, I m so excited I just got my Emulator II a couple days ago. I grew up with an Ensoniq Mirage in the 80 s and have wanted one of these since then!
Re: Supporters for Reverse Engineering needed
2008-08-16 by magmusic75
The Datex DTX200 looks like it might be a good option. i wonder if it supports the Shugart SA465 Protocol? Thanks for the info. john ...
Re: [emulatorII-list] Re: Supporters for Reverse Engineering needed
2008-08-16 by Tom Zimnicki
You may want to look here and see if these may be helpful: http://jeanfrancoisdelnero.free.fr/floppy_drive_emulator/index.html
Re: Supporters for Reverse Engineering needed
2008-08-14 by hoschi1103
I thought of a single module that fits in place of any disk drive. The SD holds many single raw disk images, one file for each disk. Filename is displayname.
Re: How Can I Copy EII Service Disk's. ( Memory test / Scanner Test) ?
2008-08-14 by magmusic75
I will give that a try and let you know if it works. ... disk s ... to
Re: Supporters for Reverse Engineering needed
2008-08-14 by magmusic75
[:)] Yes Floppy emulation does seem like a more practical solution. Like I said at a minimum it would be great just to be able to boot and load the OS from
Re: Supporters for Reverse Engineering needed
2008-08-13 by hoschi1103
It could be done by a flash or eprom, but that would need at least some extra circuits for chip/address multiplexing and severe code rewriting. Using a fpga
Re: How Can I Copy EII Service Disk's. ( Memory test / Scanner Test) ?
2008-08-13 by hoschi1103
I ve no EII at hand here on my job site, but if you start a diskcopy on EII and exchange the source os disk with a service disk when the display reads start
Re: [emulatorII-list] Re: Supporters for Reverse Engineering needed
2008-08-13 by Cristea Eusebiu
Hi, I am interested too, especially for PC. I am ready to sustain also this important project financially. ... From: magmusic75
Re: Supporters for Reverse Engineering needed
2008-08-12 by magmusic75
Hello I fully support your effort. I think that somehow getting the floppy OS (Disk Overlay) onto an EPROM and then having it programmed so the EII looks for
How Can I Copy EII Service Disk's. ( Memory test / Scanner Test) ?
2008-08-05 by magmusic75
I have an original EII Service manual with the original service disk s i would like to find a way to copy them beacuse these are super hard to find. any info
Re: OT: Emulator-1 Group Located
2008-07-24 by hexafuzz
... Thanks for the heads up, I will add this to the links section. Heres the link to the group home page: http://launch.groups.yahoo.com/group/EmulatorOne/
Re: [emulatorII-list] Re: OT: Semi off topic adding mid to an E1 - Files uploaded
2008-07-24 by GG
I ve got some info on the Emulator One MIDI interface here: http://launch.groups.yahoo.com/group/EmulatorOne/files/ ... From: hexafuzz
Re: OT: Semi off topic adding mid to an E1 - Files uploaded
2008-07-24 by hexafuzz
... No problem, and thanks for the correction. :) ... Mike, I just removed the pics because they belong in the Emulator-1 folder in the *photos* section.
OT: Semi off topic adding mid to an E1 - Files uploaded
2008-07-24 by Kenneth Abildgaard | OIIO
Yeah. Sorry ’bout the OT. Thanks for the files Mike. Kenneth Fra: emulatorII-list@yahoogroups.com [mailto:emulatorII-list@yahoogroups.com] På vegne af Mike
OT: Semi off topic adding mid to an E1 - Files uploaded
2008-07-24 by Mike de Vries
Sorry about the whole OT thing. The pics are up there in the Emu1 files. regards Mike Start at the new Yahoo!7 for a better online experience.
MOD: E-1 Posts Re: OT: Semi off topic adding mid to an E1
2008-07-24 by hexafuzz
Hey Guys, A quick moderator note concerning the recent proliferation of Emulator-1 posts: This is a dedicated Emulator-2 group and always has been. This
SV: SV: [emulatorII-list] Semi off topic adding mid to an E1
2008-07-24 by Kenneth Abildgaard | OIIO
Hi Mike. I have the RS232 port on my E1 and I even have the MIDI diskette for it. BUT NO MIDI INTERFACE J I would be very interested in seeing some internal
Re: SV: [emulatorII-list] Semi off topic adding mid to an E1
2008-07-24 by Mike de Vries
I ve got a midi interface for my EI, but you do need to power up the E1 with a MIDI OS disk in to use it. As far as I can seen, it s stuck on midi channel 1,
SV: [emulatorII-list] Semi off topic adding mid to an E1
2008-07-23 by Kenneth Abildgaard | OIIO
This would be possible with the JLCooper MIDI Interface they built. Or maybe if someone with this particular unit would share the schematics or take some pics
Semi off topic adding mid to an E1
2008-07-23 by Kevin Kelley
Hello I have an E1 without midi or CV and I would like to be able to control note on/off commabds from my PC is there any way to do this? Kevin Kelley P.S. if
Communication problem between PowerPC with SD and EII
2008-07-23 by brian_ronn
Hi SD won t communicate with the EII without preparring the EII before sending banks. I have to put the EII under control of Macintosh, to be able to send
Supporters for Reverse Engineering needed
2008-07-22 by hoschi1103
I should learn to sort my docs... Scanner CPU shows ***Emulator 2*** Boot in Progress during init, Insert Diskette of course comes from Main CPU (sent to
Emulator II bottom end.
2008-07-22 by mrjdevries
How would you all rank this? I m thinking that it s a bit on the thin side... not offensively tho.. or is this just mine? Mike.
Supporters for Reverse Engineering needed
2008-07-21 by hoschi1103
Hi all, there were no news from me for a long time, as I m always busy doing other things. Disassembling of both ROM nearly finished. Main ROM does contain
Re: [emulatorII-list] Possible Idea - Emulator I disk drive hack
2008-07-18 by GG
Mike, Do you have an application that will read data off a Shugart track arrangement? Wonder what they used at E-mu when they designed this stuff? An Apple
Re: [emulatorII-list] Possible Idea - Emulator I disk drive hack
2008-07-18 by Mike de Vries
Ideally, I d be hoping to be able to boot (power up) from the flash.. I m thinking that every disk image would be just that.. so it would be a save of the
Re: [emulatorII-list] Possible Idea - Emulator I disk drive hack
2008-07-18 by GG
Mike, I don t have a source for Sugart drives other than E-bay, and the occasional Silicon Valley dumpster:) I ve found 400L drives on all sorts of discarded
Re: [emulatorII-list] Possible Idea - Emulator I disk drive hack
2008-07-17 by Mike de Vries
Cheers, the offer is much appreciated.. But I ve got a spare semi working 400L drive here.. (Just out of interest, where did you source yours from? And If I