boot emax
press MASTER, 9, 9
Secret Code is: 3 - 6 - 2- 9 - Enter
press 8
5 HD Error Correct
Allows investigation and change of the drive error
correction state. Should be set to ON after the
diagnostics are completed.
Do you have another zip drive to test?
---In emax@yahoogroups.com, <emax@yahoogroups.com> wrote:
Hi! thanks for the support!
---In emax@yahoogroups.com, <emax@yahoogroups.com> wrote:
I did what you recommended, unplug de flat cable of the analog board and cleaned it, then restart de sampler and start without problem but when connect scsi zip drive failure again! (the wrong characters and trasnposed
pad lit) i repeat the process several times and always the same!
Is my scsi zip drive el problem?
Is my scsi zip drive el problem?
Rodolfo...
De: "sweetsynthchuck@..." <sweetsynthchuck@...>
Para: emax@yahoogroups.com
Enviado: Domingo, 20 de octubre, 2013 19:55:01
Asunto: [emax] RE: EMAX 2 werid characters on LCD and no boot!
Para: emax@yahoogroups.com
Enviado: Domingo, 20 de octubre, 2013 19:55:01
Asunto: [emax] RE: EMAX 2 werid characters on LCD and no boot!
TRANSPOSE - Turned off if the analog jack port is
detected. This will remain lit if the
analog board is not plugged in.
try reseat your analogue board connecter
detected. This will remain lit if the
analog board is not plugged in.
try reseat your analogue board connecter
---In emax@yahoogroups.com, <emax@yahoogroups.com> wrote:
Hi!, just few minutes ago i try to start up my EMAX 2 and some strange
charaters appeared on LCD and don't boot, the light on transpose pad is
lit! any advice! some of you lead me in the right direction here?
thanks!! sorry for the lo-fi video!: http://www.youtube.com/watch?v=i0PdArQsxzI&feature=youtu.be