I'm not sure if this led was lit, but the Emax definitely went into a crash. nothing worked when those caracters started to appear... I;m still not sure the problem has gone completely but it def helped.
---In emax@yahoogroups.com, <emax@yahoogroups.com> wrote:
Thanks Ronen!
I'll clean the LCD board and I'll see what happens!
---In emax@yahoogroups.com, <emax@yahoogroups.com> wrote:
I'll clean the LCD board and I'll see what happens!
the transpose pad liting when you had the problem?
Rodolfo...
De:
"ronen_sabo@..." <ronen_sabo@...>
Para: emax@yahoogroups.com
Enviado: Lunes, 21 de octubre, 2013 7:36:26
Asunto: RE: Re: [emax] RE: EMAX 2 werid characters on LCD and no boot!
Para: emax@yahoogroups.com
Enviado: Lunes, 21 de octubre, 2013 7:36:26
Asunto: RE: Re: [emax] RE: EMAX 2 werid characters on LCD and no boot!
I had (maybe still have) this problem... I touched the LCD board,cleaned it a little and now it's good.
---In emax@yahoogroups.com, <emax@yahoogroups.com> wrote:
Hi! thanks for the support!
---In emax@yahoogroups.com, <emax@yahoogroups.com> wrote:
I did what you recommended, unplug de flat cable of the analog board and cleaned it, then restart de sampler and start without problem but when connect scsi zip drive failure again! (the wrong characters and trasnposed
pad lit) i repeat the process several times and always the same!
Is my scsi zip drive el problem?
Is my scsi zip drive el problem?
Rodolfo...
De: "sweetsynthchuck@..." <sweetsynthchuck@...>
Para: emax@yahoogroups.com
Enviado: Domingo, 20 de octubre, 2013 19:55:01
Asunto: [emax] RE: EMAX 2 werid characters on LCD and no boot!
Para: emax@yahoogroups.com
Enviado: Domingo, 20 de octubre, 2013 19:55:01
Asunto: [emax] RE: EMAX 2 werid characters on LCD and no boot!
TRANSPOSE - Turned off if the analog jack port is
detected. This will remain lit if the
analog board is not plugged in.
try reseat your analogue board connecter
detected. This will remain lit if the
analog board is not plugged in.
try reseat your analogue board connecter
---In emax@yahoogroups.com, <emax@yahoogroups.com> wrote:
Hi!, just few minutes ago i try to start up my EMAX 2 and some strange
charaters appeared on LCD and don't boot, the light on transpose pad is
lit! any advice! some of you lead me in the right direction here?
thanks!! sorry for the lo-fi video!: http://www.youtube.com/watch?v=i0PdArQsxzI&feature=youtu.be