Emax

Hello Ted,
It turns on normal and ask for 'Insert disk!'. If I load the OS3.2 disk that came with Emax, it loads it and gives error message: 'CRC error', and hangs. If  I put one of my own disks (OS1.1 HD) it loads and says: 'wait a moment' loads the disk and display the loaded bank/preset and then hangs, i.e. it doesn't matter which buttons I press, nothing happens. The 'Enter' led lights up as normal but no other leds (except for 'Analog processing'-led at beginning) or any sequences of leds turns on. So I don't get any hint from some diagnostic check at start up. 
The technical manual says; Problem: 'Software loads and then display goes blank', Solution: 'Change bad scanner MPU'.
But in my case the display keep showing the loaded sound/preset and the whole front panel is locked/don't respond to any button pushes. The only led that stays on is the 'Enter' led.
 
Thanks in advance,
Marko

--- Den lör 2008-06-21 skrev Ted Summers <djtbs1@...m>:

Från: Ted Summers <djtbs1@...>
Ämne: Re: [emax] Re: Problem with Scanner MPU?
Till: emax@yahoogroups.com
Datum: lördag 21 juni 2008 02.18






When you say it loads the disk and just hangs there. what exactly 
happens.

Sequence of evemts- what leds come on on the panel and do they stay 
on or change?
What shows in LCD? Does it say diagnostics, then loading software or 
only diagnostics. These are all important because there may be other 
explanation.

Regards.
Ted
 














      __________________________________________________________
Går det långsamt? Skaffa dig en snabbare bredbandsuppkoppling. 
Sök och jämför hos Yahoo! Shopping.
http://shopping.yahoo.se/c-100015813-bredband.html?partnerId=96914325


[Non-text portions of this message have been removed]