Emax

I would be interested to know if anyone has sucessfully installed an 
internal ZIP drive that they can boot from.  I have just got hold of an 
Iomega ZIP 100 (model Z100Si) drive which has fitted nicely into the 
drive bay.  I don't have a 50-pin scsi cable yet so I haven't tested it 
yet but it powers up fine.  One thing I am a bit worried by is the fact 
that the jumper setting diagram on top of the drive doesn't have a 
diagram for ID '0' only IDs 1 through to 6.  

In my last post on this board I was told that the Emax will only look 
at SCSI ID 0 to boot up.  My only hope is if I take all of the jumper 
blocks off the SCSI ID pins then this will be SCSI 0?

Any ideas on that?  What internal ZIP drives are other people using??

Thanks.