David, Thank you for a logical repliy. To be honest, when I made the targets, I don't recall if I turned of color management in the epson driver. I probably didn't and I think that right there is the problem. At my age I get to play the "senior moment card'. 8^} As I replied in another post to you, I did open a tickect and will be sending the file in a few minutes. As far as putting the targets in a drawer for a month was because I wanted to give them a day to make sure they were completly dry, and just wasn't able to get back to them as soon as I wanted to. Yes, I do know that I was making a measurement file(reading the targets) and when I was stepping through the process, this is what I selected to print the test image from within S3P. I dated the target so I know which to select. I'm trying to sent the files, but when I click on the partial email addy from above, outlook asks for a complete address so I filled in datacolor.com. I hope you get it. In the mean time, I will get paper ready for another test. This may sound like a dumb question, but does it matter if the spyder is plugged in or not while making the the test print-after reading the measurement targets? I would think it would have no bearing, but I don't know so I asked the question.