Datacolor User to User Support Group.

I'm using Spyder Print 3.5b WinXp

When I choose 720 patches on 3 sheets it doesn't include the grays.
So I print the three sheets 

Then I want the Extended grays with any other target so I print that.

I go to the read patches page and under "Save measurements to"  I can choose EITHER 729, 3 sheet  OR Extended Grays

I  can save measurements to a new file "New test file"
Then what? Do I go back to "save measurement to" and make a gray measurement set?

If I do does that OVER WRIGHT or ADD to the original 729 file?

If I choose "Select an existing measurement file from the list" there is no  file for the "new text file extended grays" so I have to create one.  Which brings me back to how to do that?

If I go to the "save measurements to.."  
I get the message? A file named " 'test file.xml' aleady exists".
It does not say at that point if the new file adds to or overwrights the 729 patches!!  

What am I supposed to do?

One thing that seems reasonable is to "select an existing measurement file from the list below" and hope I can choose my 729 set and ADD the grays, but no such luck - too simple. The is no way to check the check box where it says " 'Use extended Gray' from:"  so Im stuck on that route.

I am guessing you are too close to this software to see this.
That's normal


What is extraordinary is how quick you are to give help.

  Thanks

______________________________________
When I do 


--- In datacolor_group@yahoogroups.com, Cdtobie <CDTobie@...> wrote:
>
> Check the menus and see if there is a menu command for merging  
> measurement sets. If not, you will need to select the four page  
> template, and remeasure the patches into it.
> 
> C. D. Tobie
> Global Product Technology Mngr.
> Digital Imaging & Home Theater
> Datacolor.com
> CDTobie@...
> 
> On Mar 6, 2010, at 6:05 PM, "Phiegze" <swp91011@...> wrote:
> 
> > I can't figure out how to add the extended grays to my existing  
> > profile.
> >
> > I printed 729 Patches on three sheets and Extended Grays the 4th  
> > sheet.
> >
> > I've measured and created a profile ("Staples Glossy Cone 1400.icm")
> > and I've have a measurement file for the Grays ("Staples Glossy 1400  
> > Grays.xml")
> >
> > How do I get to the next step of creating a profile INCLUDING the  
> > Grays?
> >
> > I hope there is someone there to give me a clue as I'd love to get  
> > back to printing.
> >
> > Thanks
> >
> >   Steven
> >
> >
> >
> >
> > ------------------------------------
> >
> > Yahoo! Groups Links
> >
> >
> >
>