Cgs synth

New lay out. wont go up into audio range when S to L jumper is in.
cut the jumper & they cycle as VCOs/ no problem. Any recommendations ?
Change the 33k & 15k resistors near the L pad ???
thanks in advance !
d

try shorting out the 330R resistor at pad S. (and looking for construction
errors)

Ken

Thank you . i tried shorting the 330r. , tried changing values of the 33k ,
no luck.
It samples beautifully with the jumper in & cycles great with jumper out.
Seems to be stuck holding when i patch it to cycle with the jumper in. I
used a BC557 backwards to the footprint.
d

--
http://www.facebook.com/dmitri.sfc

http://www.residentadvisor.net/dj/dmitrisfc

http://twitter.com/dmitrisfc


[Non-text portions of this message have been removed]

uh yes im a freak !!
When using the lower half of SSG as Suqare wave VCO you mult out of the
Cycle & In jacks to get the Square !
(Not the stepped out !) & The new lay out with the bi-polar LED drivers is
working great!
Thank you Ken!!
D
--
http://www.facebook.com/dmitri.sfc

http://www.residentadvisor.net/dj/dmitrisfc

http://twitter.com/dmitrisfc


[Non-text portions of this message have been removed]