pcb switches
2007-01-11 by Andrew Scheidler
In building the Gate Sequencer switch board, I'm thinking I should mount
the switches in the front panel (not tightly, just snug), lay that face
down, then place the PCB onto the switch pins and solder.
Doing this would ensure that things are lined up properly when
soldered... is this a good way to do it? Or is there a potential
problem I'm not foreseeing?
thanks!
Andrew
the switches in the front panel (not tightly, just snug), lay that face
down, then place the PCB onto the switch pins and solder.
Doing this would ensure that things are lined up properly when
soldered... is this a good way to do it? Or is there a potential
problem I'm not foreseeing?
thanks!
Andrew