Hi Stijn,
The wiring is part of the schematic at:
http://cgs.synth.net/modules/burst_generator.html
CO (clock out) is connected to the switch lug of CI (clock in). Without
this connected your 4017 is not getting the clock, and nothing will
happen at your outputs.
I hope this helps!
Scott Deyo
The Bridechamber
contact@...
http://www.bridechamber.com
Jealous Edison Record Kompany
http://www.jealousedison.com
The wiring is part of the schematic at:
http://cgs.synth.net/modules/burst_generator.html
CO (clock out) is connected to the switch lug of CI (clock in). Without
this connected your 4017 is not getting the clock, and nothing will
happen at your outputs.
I hope this helps!
Scott Deyo
The Bridechamber
contact@...
http://www.bridechamber.com
Jealous Edison Record Kompany
http://www.jealousedison.com
On Nov 17, 2008, at 1:27 PM, stijncostermans wrote:
> I guess a wireing diagram/drawing would help, I have nothing
> connected to the swich lugs of the jacks.
> the trigger from the internal oscillator I get comes from a pin on
> the ic, not from the jacks. at none of the jacks is any signal ore\
> voltage.
>
> --- In cgs_synth@yahoogroups.com, Richard Brewster <pugix@...> wrote:
> >
> > I had a problem with my burst generators that was fixed by using a
> > different brand of CMOS IC. Hopefully you used IC sockets. I
> replaced
> > the first brand with Texas Instruments make, and all was well.
> Some
> > CMOS doesn't clock well at low frequencies.
> >
> > Richard Brewster
> > http://www.pugix.com
> >
> > Scott Deyo wrote:
> > > You're sure the oscillator is normaled to your clock input for
> the
> > > divider?
> > > I fixed someone's, and the switch and signal lugs were swapped on
> that
> > > jack.
> > >
> > > Scott Deyo
> > > The Bridechamber
> > > contact@...
> > > http://www.bridechamber.com
> > > Jealous Edison Record Kompany
> > > http://www.jealousedison.com
> > >
> > >
> > > On Nov 16, 2008, at 9:48 AM, stijncostermans wrote:
> > >
> > >
> > >> I just finished constructing a bridechamber burst generator kit
> > >> and .......it doesn't work!
> > >> ok I haven't got too much knowledge of electronics, but this is
> what I
> > >> can tell about the unit
> > >> the internal osc works fine (cd40106) the speed pot and range
> swich
> > >> work.
> > >> for the rest nothing works, no triggers whatsoever.
> > >> can anyone tell me how to go about debugging this thing? what
> voltages
> > >> I should read where.
> > >>
> > >> tnx
> > >>
> > >> cheers,
> > >> Stijn
> > >>
> > >>
> > >>
> > >>
> >
>
>
>
[Non-text portions of this message have been removed]