Bc2000 (for the BCF2000 & BCR2000)

Now I tried to send to the Interface BCR2000 and not BCR2000-A or B. Now 
its works. In the past I always got a Err22 Error over the BCR2000 
Interface. But now Its works.
Thank you Royce. Your Editor Is nice! Would be cool when the Editor have 
a search and replace function, to set multiple Parameters at one 
time(like MIDI Channel of all Elements, or edit Modes on all Push 
Encoders...etc).

Carma Trepp schrieb:
>
> Hi Royce
>
> I configured ID 1 and 2 on the BCR. Then I try it on your and birdies 
> editor. Same Problem with Device ID all(on your editor), and 1 or 2.
> Still only see the flashing light on the MIDI In.
>
> I tryed the connection over USB and a MIDI Interface.
>
> rpcfender schrieb:
>
>> Hi Carma,
>> these sound like the symptoms you get when your BC has a device number
>> doesn't match the sysex.
>>
>> There are a few ways around this...
>> Change the Device ID. Enter Global Edit mode by pressing both "Store"
>> & "Edit" on the BC.
>> Encoder 5 (Top row) is the device ID. Start with Id 1 and see if this
>> fixes it. "Exit" to get out of global mode before you send the sysex.
>>
>> On Birdie's editor there is a dropdown box on the left near the top
>> labeled "SysId" Set it to match you BC Id or set it to 0x7F which
>> means ignore the Id
>> (0x is the bit that says the number is in hexadecimal for the non C
>> programmers out there. 0x7F is the same as $7F in BCL)
>>
>> I have fixed the ID setting in my editor. Make sure you have the
>> latest version.
>> Go to the "Save & Get" page and on the right there is a panel called
>> "Sysex Header Bytes" and the Id button is below this.
>> If it is set to "all" then it shouldn't matter what your BC is set to.
>>
>> Let us know if this doesn't fix the problem.
>>
>> Royce
>>
>> --- In bc2000@yahoogroups.com <mailto:bc2000%40yahoogroups.com>, 
>> Carma Trepp <carma_trepp@...> wrote:
>> >
>> > Hi all
>> >
>> > I try to transmit a sysex preset I made. I can transfer it without
>> > errors. During the transfer I only see the MIDI In is flashing, but 
>> the
>> > LED does not circle.
>> > After that I dont see my config on the actual preset. I tried a
>> preset I
>> > made from Birdies Editor. And try to transfer with Birdie and 
>> midiox. I
>> > have firmware 1.10.
>> >
>> > Carma
>> >
>>
>
>