Bc2000 (for the BCF2000 & BCR2000)

A great thank you for your particular explanation Roys. I will test this 
in the evening.


rpcfender schrieb:
>
> Hi Carma,
> these sound like the symptoms you get when your BC has a device number
> doesn't match the sysex.
>
> There are a few ways around this...
> Change the Device ID. Enter Global Edit mode by pressing both "Store"
> & "Edit" on the BC.
> Encoder 5 (Top row) is the device ID. Start with Id 1 and see if this
> fixes it. "Exit" to get out of global mode before you send the sysex.
>
> On Birdie's editor there is a dropdown box on the left near the top
> labeled "SysId" Set it to match you BC Id or set it to 0x7F which
> means ignore the Id
> (0x is the bit that says the number is in hexadecimal for the non C
> programmers out there. 0x7F is the same as $7F in BCL)
>
> I have fixed the ID setting in my editor. Make sure you have the
> latest version.
> Go to the "Save & Get" page and on the right there is a panel called
> "Sysex Header Bytes" and the Id button is below this.
> If it is set to "all" then it shouldn't matter what your BC is set to.
>
> Let us know if this doesn't fix the problem.
>
> Royce
>
> --- In bc2000@yahoogroups.com <mailto:bc2000%40yahoogroups.com>, Carma 
> Trepp <carma_trepp@...> wrote:
> >
> > Hi all
> >
> > I try to transmit a sysex preset I made. I can transfer it without
> > errors. During the transfer I only see the MIDI In is flashing, but the
> > LED does not circle.
> > After that I dont see my config on the actual preset. I tried a
> preset I
> > made from Birdies Editor. And try to transfer with Birdie and midiox. I
> > have firmware 1.10.
> >
> > Carma
> >
>
>