You should use BCF2000 in mackie emulation mode, this is the BEST solution.
Please go to http://www.behringer.com/EN/Support/B-Control-Downloads.aspx and download
the B-CONTROL BCF2000 Emulation modes (EN) document.
Also make sure you have BCF2000 in mode U-3 (this is USB mode 3), please check the manual for this.
The configure SONAR for a Mackie control surface (Check the help files).
Please note that there are limitations in functionality according if you use Studio or Producer version.
Also you can check this forum:
http://forum.cakewalk.com/tm.asp?m=1643630
Good luck,
Marco
To: bc2000@yahoogroups.com
From: jmrenvoise@...
Date: Tue, 26 May 2009 15:44:20 +0200
Subject: [bc2000] sonar & bcf2000
Hello,
I'm just trying sonar with the Behringer BCF2000.
As sonar indicates it, i booted the BCF2000 in B-Control mode, chose a free preset on it, then launched sonar, configured a new ACT controller and sent the "Behringer BCF2000 Custom" preset to the BCF2000 that i saved in it.
All commands from the BCF are now recieved by Sonar, but no sonar command is recieved back by the BCF.
As sonar indicates it, i booted the BCF2000 in B-Control mode, chose a free preset on it, then launched sonar, configured a new ACT controller and sent the "Behringer BCF2000 Custom" preset to the BCF2000 that i saved in it.
All commands from the BCF are now recieved by Sonar, but no sonar command is recieved back by the BCF.
How can i fix this ?
I tried to configure the faders settings of the BCF into "motor" which
normally let the BCF sliders "obey" the softwares commands, but I couldn't
access these parameters via encoder 7. This encoder let me access to params from
"1d"- to "damp". That's all.
Any hint about accessing to these ones "Move, Pick-up, Motor" ?
Any hint about accessing to these ones "Move, Pick-up, Motor" ?
Any other solution to let sonar send orders back to the BCF2000 ?
Many thanks for your anwsers
jico27
Windows Live™: Keep your life in sync. Check it out!