Akai S1000 / S1100 samplers

Hi PeWe

Thanks for the reply mate, i've been through all options and it seems the IB-103 card has an issue as i first thought.

its not good news at all if so as they dont come up to often from what i see.

Hopefully i can do a fix on it




--- In akaiS1000S1100Samplers@yahoogroups.com, PeWe <ha-pewe@...> wrote:
>
> What about troubleshooting ?
> 
> You have IB-103 SCSI card in your S-1100 w/ 50-pol Centronics connector ?
> 
> You have a ext. SCSI ZIP drive w/ 25-PIN connector ?
> 
> You have the correct cable to connect the ZIP to the S-1100 and it´s 
> working ?
> 
> You have a AKAI formatted/arranged ZIP media inserted in the ZIP-drive 
> already ?
> 
> The default SCSI ID of S-1100 is #6 ?
> 
> The SCSI ID of the ZIP drive is a different number than #6 ?
> 
> You connect the ZIP drive to the S-1100 while the S-1100 is switched 
> OFF, switch ZIP drive ON 1st and wait until the media is recognized by 
> the drive,- then power up the S-1100 ?
> 
> You´re able to access the SCSI page of the S1100, see SCSI ID #6 for the 
> sampler and ID #X for the ZIP drive ?
> 
> Your ZIP drive is terminated ?
> 
> If you checked this all and it doesn´t work and you´re a sure the same 
> SCSI cable w/ the same drive works w/ another sampler,- then it seems 
> your IB-103 SCSI board is defective.
> 
> PeWe
> 
> 
> 
> 
> 
> 
> Am 07.08.2011 23:29, schrieb nicknak110756:
> >
> > Hi Rish
> >
> > its a possibility i agree but i cant think what as its a pretty 
> > straight forward procedure.
> > i've followed the instructions laid out in the manual just in case.
> > i have the channels as they should and the connections as they should 
> > yet the sampler will still not recognise the drive.
> >
> > to add, i've just hooked my roland sampler up and the zip drive shows 
> > up on that no problems.
> >
> > like i say, i think the issue may be with the SCSI port as i cant 
> > think of anything else?
> >
> > is this fixable or is it a case of finding a replacement?
> >
> > Thanks
> >
>