When I talked to Rex the other day he mentioned bending sheet metal for a power supply. He's building some super duper supply for Bakis. I'm fairly certain the ones he uses for the masses are made by a third party. If I remember tomorrow I'll email you what my power supply says on it.
On Fri, Jul 3, 2009 at 10:24 PM, stkorn <stkorn@...> wrote:
you may well be right, that's just the impression I got when talking to him.
--- In SergeModular@yahoogroups.com, John Loffink <jloffink@...> wrote:
>
> I doubt that. Maybe Rex was bending sheet metal for an interior bracket?
>
> These cases are not something that could be built in anything less than
> a fully equipped machine shop. For instance there are weld points for
> the bottom plate and the front O channel ring. The fact is these look
> nicer than the Bud and Hammond cases I've seen.
>
> When I talked to Rex in '02 he had the power supplies built by a third
> party.
>
> John Loffink
> The Microtonal Synthesis Web Site
> http://www.microtonal-synthesis.com
> The Wavemakers Synthesizer Web Site
> http://www.wavemakers-synth.com
>
>
>
> stkorn wrote:
> > I think Rex might do them himself..when I talked to him the other day he said he'd spent the day bending sheet metal for the larger power supplies..
> >
> > --- In SergeModular@yahoogroups.com, John Loffink <jloffink@> wrote:
> >
> >> Does anyone know who manufactures the case used for the STS Serge power
> >> supplies? I am making a power supply for an older system with 6 volt
> >> power and thought it would be nice to match the current PSU cases, plus
> >> I like the wrap around ventilation.
> >>
> >>
> >
>