QTR-Quadtone RIP

Stephen

My testing seems to confirm that a problem exists in this area. When I start
up QTR now, the Printing Model model defaults to Quad2200. If select a curve
set within that model, and exit, that curve set is still selected when I
restart. However, if I select another model and curve set and then restart,
the printer model reverts to Quad2200 Printing Model and the curve selection
is reset to blank. This behaviour is different from the previous version (I
think).

On another note, if I start QTR and while it's already running (which I did
by mistake), QTR crashes with an access violation. Obviously I shouldn't be
doing that, but I shouldn't be able to cause a crash either.

Tom Moore

> -----Original Message-----
> From: QuadtoneRIP@yahoogroups.com [mailto:QuadtoneRIP@yahoogroups.com] On
> Behalf Of Stephen Billard
> Sent: Thursday, November 16, 2006 6:27 PM
> To: QuadtoneRIP@yahoogroups.com
> Subject: RE: [QuadtoneRIP] 2.4.3.10
> 
> You should not have to. These settings are stored in an "ini" file in your
> Documents and Settings folder. Look under "Application Data/QuadToneRIP".
> The
> only reason the settings might not get updated is if QTRgui does not close
> normally.
> 
...
> -----Original Message-----
> From: QuadtoneRIP@yahoogroups.com [mailto:QuadtoneRIP@yahoogroups.com] On
> Behalf
> Of phkowalchuk
> Sent: Wednesday, November 15, 2006 10:17 PM
> To: QuadtoneRIP@yahoogroups.com
> Subject: [QuadtoneRIP] 2.4.3.10
> 
> Just upgraded. I wonder why every time I use the app, I have to reset my
> printing model and curves? In the 2.3 version I had prior, this was not
> the
> case. Yet my ink limit and gamma adjustments are remembered.
> 
> 
>