Vector T-Struts?
2006-10-15 by Joe Grisso
Hey gang,
I'm starting to design my own custom case using the Vector TS600's that were used in those sexy plexi cases earlier. There's a limited amount of info on the mechanicals from Vector's site, and I was hoping you fine folks would be able to lend a hand. Vector's ordering information states that the TS600 is 1.75" wide, but points to figure 3 on page 41 of their catalogue, which gives a mechanical spec of 1.0" wide. I would assume that the TS600 is like the TSW300, with only one side having slot for the nuts and the opposite side being just solid bar stock - but I'd like to know so I can model it properly in SolidWorks before pulling the trigger on buying all the parts.
Thanks for all the help!
Joe Grisso,
Detachment 3 Engineering
I'm starting to design my own custom case using the Vector TS600's that were used in those sexy plexi cases earlier. There's a limited amount of info on the mechanicals from Vector's site, and I was hoping you fine folks would be able to lend a hand. Vector's ordering information states that the TS600 is 1.75" wide, but points to figure 3 on page 41 of their catalogue, which gives a mechanical spec of 1.0" wide. I would assume that the TS600 is like the TSW300, with only one side having slot for the nuts and the opposite side being just solid bar stock - but I'd like to know so I can model it properly in SolidWorks before pulling the trigger on buying all the parts.
Thanks for all the help!
Joe Grisso,
Detachment 3 Engineering