PLAN B analog blog

What is with me and typing? 

Have you ever noticed I usually screwup the money words?  All the
and's, but's, if you's are OK, then I come to the part of the exact
location of the problem and it's at the sispo sjsiu wwiwoim, and I
send that without proofing.  It's uncanny.

Anyway, I meant the LOWER gate, not the POWER gate (below):




--- In PLAN_B_analog_blog@yahoogroups.com, "(i think you can figure
that out)" <peter@...> wrote:
>
> You will notice two trim pots on the M13 PCB. To make the inputs less
> sensitive, just back those down.  The upper trimmer is for the upper
> gate, the lower trimmer is for the power gate.
> 
> As far the amp mode - this is a function of the beast.  Some of what
> you're hearing is no filtering, as that amplifies certain frequencies,
> and the other is the energy drop through the circuit by bypassing the
> FET tha drives the sallen-key filter inside.
> 
> - P
> 
> 
> 
>  --- In PLAN_B_analog_blog@yahoogroups.com, "jalmari3"
> <jari.jokinen@> wrote:
> >
> > I like M13 too.
> > 
> > Although I wonder, why the VC inputs are so sensitive. I just tested 
> > Gate 1 of my unit: It tops at 4.3V. This often necessitates
attenuation 
> > of the CV signal. (I would gladly change the offset controls to VC 
> > input attenuators.)
> > 
> > Also, the amp only mode is much quieter, than other modes.
> > 
> > Best regards
> > Jari Jokinen
> >
>