Marcos Maniacs

Mark,

I looked in my spares and all I have is 7/8" and 1" rubber seals.  My 
rear brake cylinders are 3/4" also.  Any foreign auto parts store 
should have Girling kits.  I ended up getting Volvo kits at the local 
shop.  Just have them look up brake kits and get a 3/4" one.  The 
seals are all about the same.  I used a brake master cylinder 3/4" 
seal to replace my clutch slave cylinder seal?!

Good luck!  Hope you can make Davis show on Saturday.

Don Lattimer
#3m5759 V6

--- In MarcosManiacs@y..., markwoof92@a... wrote:
> Hi Don.
> What is the bore on your cylinders?Mine is 3/4 inch but I am not 
sure that 
> this is the correct bore .And what do the rest of you all out there 
say?    
> Mark P.