Homebrew PCBs

Hey all! I am a new guy, and new to PCB making in general.. I ran
across this site searching for LED tail light making actually..

I am hopefully going to be making my PCBs using the toner transfer
method (When I can get me a cheap laser printer, heh).. But I need to
first figure out exactly HOW I am going to go about making these LED
tail lights! I actually got this idea from following a new Cadillac
Deville a few months ago, and all I said was I want that..

I am curious, where do most of you get your PCBs from? Radio Shack? I
have like 50 of those in a 5 block radius it seems, so I could easily
go there, lol.. 

A note on the LEDs I will be using: I'm looking at getting the red
SuperFlux LEDs, or I may spring for the red-orange snapleds.. Not sure
here yet..

I look forward to any pointers you all as the Masters may have for
this humble noob..

<<Note from moderator- the LED discussion should be moved to the Electronics_101 list>>
http://groups.yahoo.com/group/Electronics_101