--- In Homebrew_PCBs@yahoogroups.com, "mikezcnc" <eemikez@c...> wrote:
using .062 (regular thickness) copper clad material, you will need to
modify the unit. Its not hard unless one is mechanically challenged.
Here are the instructions:
<http://www.pulsar.gs/1-tts/c_pcb/pcb_pages/5_the_ideal_PCB_setup/support/TIA%20Modifications.pdf>
read them thoroughly and then read them again. It can be a bit confusing.
I'm not sure at what thickness you don't have to modify but I do know
that the 0.031 material feeds ok through an unmod'd device. The
Electronic Goldmine is selling that stuff but they seem incapable of
actually shipping an order these days.
>This unit works pretty well but you should be aware the if you are
> Alvin,
>
> The laminator is made by GBC and model that I use and recommend is
> H200, 8.5x11" about $100.
>
> Good luck.
>
> Mike
>
using .062 (regular thickness) copper clad material, you will need to
modify the unit. Its not hard unless one is mechanically challenged.
Here are the instructions:
<http://www.pulsar.gs/1-tts/c_pcb/pcb_pages/5_the_ideal_PCB_setup/support/TIA%20Modifications.pdf>
read them thoroughly and then read them again. It can be a bit confusing.
I'm not sure at what thickness you don't have to modify but I do know
that the 0.031 material feeds ok through an unmod'd device. The
Electronic Goldmine is selling that stuff but they seem incapable of
actually shipping an order these days.