Homebrew PCBs

On Mon, 31 Dec 2012 11:37:48 -0800, you wrote:

>On 12/31/2012 10:56 AM, Andrew Hakman wrote:
>>> There used to be a small tool that was used to create an island around
>>> a drill hole. it was effectively a micro sized hole saw. The
>>> technique was to drill holes in copper clad where you wanted them,
>>> isolate this hole with the tool (as needed) and then bridge from
>>> island to island with the parts.
>> [Non-text portions of this message have been removed] 
>> ------------------------------------ 
>Try this one:
>
>http://www.vectorelect.com/Catpdf/New%20Page%2075-78.pdf

That would be it.  The number is even familiar.

Harvey

>
>Norm
>W6NIM