Homebrew PCBs

John P. Anhalt wrote:
> The insulation on the wire I use is heat sensitive.  I run the tip of my soldering iron along one side.  That essentially removes a small strip of insulation.  The insulation can then be peeled back from the wire as far back as the strip and clipped off in the usual manner.  The wire I use is from RadioShack and unfortunately the actual manufacturer is not listed for it.  John
>  
>  
If you are using Radio Shack's 30-gauge wrapping wire, then just get 
their wire wrapping tool:
http://www.radioshack.com/product/index.jsp?productId=2103243

It comes with a wire stripper that strips this wire perfectly.  But only 
a strip-mall RadioShack will carry this tool.

Cheers,

Bryan