Homebrew PCBs

it works!!!!

i made a deep plastic box for fuming with super glue 
{like finger prints}
and it worked   the print went black and hard

i used a solder iron for fast fume creation
added a 1n5407 in series with a switch to short over it
with the live in the plug 
to half the total heat of the iron {25w} 
to ~12watts

two drips of super glue5 {loctite} 
on its end {i added a little cup to the iron}

and set the pcb in the fume area the iron will produce 
using a wire stand {1mm ecw}

so much for the doubting toms

go give it a try with mispro  prints see if its better
for fine lines

anyway ill etch it after dinner 
and post all photos in my yahoo site  then,,,, {8pm gmt or so}

on initial inspection even thin broken tracking seems hard
 
as it appears the resins in the inks 
{basicaly the polymer its made from} 

goes black as expected 


it may turn out pigment {plastic} inks are better