Homebrew PCBs

>> Me wrote:
>> What kind of mill do you have and what are you
>> planing on doing with it ?
 
> Cristian wrote:
> Bungard's CCD2 intended to be modified (it is not
> software modification-friendly) to mill/drill
> pcbs


Um - the Bungard CCD2

http://www.bungard.com/seiten/p-ccd_2.htm

Looks like it already mills PCBs ???


Anyways - if you do want to run it with your own
software/hardware then it should not be too hard.

Look at the link I sent before about Linux EMC.

It can connect straight to the L297 type
controllers shown here

http://pminmo.com/


L297s are very low tech and pretty dodgy - but
then again that thing from bungard is hardly
21st century with "high torque stepper motors"


If you want to go servo motors do a google
search for 

"ELM servo"

and you will find a tidy little atmel servo
controller some nice bloke has done.