Homebrew PCBs

maybe you can get the zweckform/avery paper i use (in Austria)?
Look in the database section for the number.

ST


On Sun, 12 Feb 2006 18:01:08 +0100, protonceksleeperman  
<protoncek@...> wrote:

> Hi folks!
>
> As all of you, i'm trying to make my first PCB, too. And, as many of
>
> you, i too have problems. I tried several papers, (since i'm in
>
> Europe, i can't get a hold of those mentioned in groups, usually from
>
> USA), and most of the times some of the toner peels off, while last
>
> layer of paper is very hard to remove. I have measured temp on my
>
> iron, and it's about 230 degrees, so it is enough. I even tried with
>
> lower temp (about 200) but results were the same.
>
> So, i guess my next try is transparency. But, here i need some info,
>
> please. Like what do you do toi prevent transparency to crook
>
> (distort) from heat? Maybe by applying iron on parts and not on whole
>
> board? how long should all last? And would transparency work in
>
> laminator?
>
>
> Any of suggestions would be very welcome.
>
>
> Thanks! Paul, Slovenia