Doepfer

Hi,

I bought a couple A-111 VCO's but the tracking on them is way out (didn't know this until i built my new system), is there a technical calibration procedure somewhere on the Doepfer site or do I have to send them back to the factory to be setup again and if so how much does it cost and how long would it take.

Regards

Paul

I think the A110 procedure mostly goes for the A111 too.
The A110 version is here: http://www.doepfer.de/a110_tec.htm
I'm not sure though...



On Sun, Mar 28, 2010 at 11:51 PM, paulshillito <
paul.shillito@classitronic.net> wrote:

>
>
> Hi,
>
> I bought a couple A-111 VCO's but the tracking on them is way out (didn't
> know this until i built my new system), is there a technical calibration
> procedure somewhere on the Doepfer site or do I have to send them back to
> the factory to be setup again and if so how much does it cost and how long
> would it take.
>
> Regards
>
> Paul
>
>  
>


[Non-text portions of this message have been removed]

> I think the A110 procedure mostly goes for the A111 too.
> The A110 version is here: http://www.doepfer.de/a110_tec.htm
> I'm not sure though...

That's true. And we have a pdf document on the A-111-1 info available named
"short version of the adjustment procedure".

It's always a good idea to look at the info page of a module if you have any
questions:

www.doepfer.com > PRODUCTS > A-100 > Module Overview > Module in question

Best wishes
Dieter Doepfer