Doepfer

Thank you Dieter,

My system has an A190-1 so there must be 5v power in the lower row. Now I have to scratch my head to work out which modules I can take out for the moment to play with the LDB!! I'm saving for a Monster Base but my plan to buy it next week has had to change due to people not paying their bills!!!

Thanks again,

David

www.movingisliving.co.uk

Sent from my iPhone 

> On 25 Sep 2014, at 10:04, yahoo@doepfer.de [Doepfer_a100] <Doepfer_a100@yahoogroups.com> wrote:
> 
> If the +5V control LED on the right end if the bus boards is "on" this bus
> board has +5V available. Otherwise you have to install the A-100AD5.
> Older versions of the A-100BS2 (with interface A-190-1) were equipped with
> an A-100AD5 in the lower row. The new versions (with A-190-4 interface
> instead of the A-190-1) are no longer equipped with the A-100AD5 as the
> A-190-4 does no longer require +5V.
> If you need +5V in the upper row an A-100AD5 has to be installed in any
> case.
> 
> Hope this helps
> Dieter Doepfer
> 
> > -----Ursprungliche Nachricht-----
> > Von: Doepfer_a100@yahoogroups.com [mailto:Doepfer_a100@yahoogroups.com]
> > Gesendet: Donnerstag, 25. September 2014 10:01
> > An: doepfer_a100@yahoogroups.com
> > Betreff: [Doepfer_a100] Does my case have 5v?
> >
> >
> > Hi,
> >
> > I have a Basic System 2 in a silver 19" Doepfer rack. On the
> > power rail I can see that one pin is labeled 5v. Does this mean I
> > DON'T need a separate 5v supply for a module that needs 5v? I
> > have a Delptronics LDB 1e arriving later today that needs 5v
> >
> > Thanks for help,
> >
> > David
> >
> > www.movingisliving.co.uk
> >
> 
>