Thanks guys for all your reactions!
At this moment all three A111 are in the top row. Best is probably to put one in the bottom row. Then add an A185-1 in both rows and connect them to the A190 in the other cabinet.
I think I'll just buy a few and try them out, see and hear what happens.
---In Doepfer_a100@yahoogroups.com, <maq163x2@...> wrote:
I don't have an A-185, but I think you are correct. The A-190 should provide CV/Gate to Case 1 (only the modules in the same 3U row as the A-190, unless you have the extra cable to connect your bus boards). The sockets on the A-190 can send the signals to the other case's A-185, so the A-111s and A-141 can be fed from the Case 2 system bus (again, only the same row as A-185 unless you have the bus board connection cable).
That should drive your VCOs without any tuning issues ... I think....
Nick
On Nov 6, 2013, at 12:23 AM, <karelvanbezooijen@...> wrote:
Please tell me if I'm right or wrong.
I have a few cases with modules:
Case 1: standard basic system 2 with 2 x VCO 110 and A-190
Case 2: another case with 3 x VCO 111 plus A-141 VCADSR.
In order to control Case 2 with the same gate and CV from the A-190 I only need an A-185-1 in Case 2.
When I connect The A-190 to the A-185-1 it should be allright, right?
I read the A-185-1 manual but why should I also put an A-185-1 in Case 1?
regards,
Karel van Bezooijen