Doepfer

btw, also the a190-1 and a164 send cv and/or gate signals to the busboard.



Bakis Sirros - Parallel Worlds / Interconnected / Memory Geist

[Doepfer_a100] group owner

www. parallel - worlds - music. com

www. myspace. com/ parallelworldsmusic

www. myspace. com/ interconnectedmusic

www. myspace. com/ memorygeist

www. DiN. org. uk

www. musicamaximamagnetica. com

www. vu-us. com

--- On Fri, 11/12/10, Bakis Sirros <synth_freak_2000@yahoo.com> wrote:

From: Bakis Sirros <synth_freak_2000@yahoo.com>
Subject: Re: [Doepfer_a100] Re: A-190-2 front cv1 (note) seems to not work properly
To: Doepfer_a100@yahoogroups.com
Date: Friday, November 12, 2010, 10:36 AM







 



  


    
      
      
      do you happen to have another module sending cv/gate signals to the same busboard?

(like the a185-1 or a185-2)

if yes, then you have to remove the jumper sending cv/gate signals to this busboard, from your 190-2 or from the other module.



Bakis Sirros - Parallel Worlds / Interconnected / Memory Geist



[Doepfer_a100] group owner



www. parallel - worlds - music. com



www. myspace. com/ parallelworldsmusic



www. myspace. com/ interconnectedmusic



www. myspace. com/ memorygeist



www. DiN. org. uk



www. musicamaximamagnetica. com



www. vu-us. com



--- On Thu, 11/11/10, contourmixer <contourmixer@yahoo.ca> wrote:



From: contourmixer <contourmixer@yahoo.ca>

Subject: [Doepfer_a100] Re: A-190-2 front cv1 (note) seems to not work properly

To: Doepfer_a100@yahoogroups.com

Date: Thursday, November 11, 2010, 7:37 PM



 



--- In Doepfer_a100@yahoogroups.com, <yahoo@...> wrote:



>



> > the back connection that goes to the buss send the right midi



> > note information but the front jack is an octave higher! and the



> > C# is a D, the D is an E and it just gets stranger from there on.



> > i know the unit is in V/Octave mode and am stumped any help



> > please? i did also try to tune the pot on the back as well with no luck



> 



> The internal bus CV and CV available at the front panel of the A-190-2 are



> hardwired. They are separated only by the jumper JP3. I cannot imagine how



> it's possible to get two different CVs. The trimming potentiometer is used



> to adjust the 1V/octave scale.



> 



> Best wishes



> Dieter Doepfer



>



if i take out JP3 it works fine in the front cv but if its in then the pitch in the front goes crazy again? ar they adding together? do i need to take out the jumper every time to use the font cv?



thanks in advance



[Non-text portions of this message have been removed]





    
     

    
    


 



  






      

[Non-text portions of this message have been removed]