Doepfer

Related to an earlier post I had created regarding my A110.  This module seems to be "flakey."

I have it connected correctly red stripe down at both ends.  When I turn on my case, it does not produce any sound.  I thought maybe it had to warm up or something.

I have the sine output going directly to an A130 audio in and then directly to a linear A138 audio in.  No sound comes out.

But if I take the ribbon cable off the module (several times), eventually it begins to work.  I thought the ribbon connector was bad, so I tried another one and same thing occurs.

This is a drag because I would like to have the module mounted in the rack and I also don't want to "short out" the case.

Any advice?

Thanks


Steve B