Doepfer

Thanks Florian
 
David
 
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* * *
David Salter
Senior Consultant
SSG UKI

Thomson Reuters

O +44 (0)20 7542 2402X 52402
M 07990562402

david.salter@thomsonreuters.com
thomsonreuters.com <http://thomsonreuters.com/> 
 
P Please consider the environment before printing this e-mail 

 

________________________________

From: Doepfer_a100@yahoogroups.com [mailto:Doepfer_a100@yahoogroups.com]
On Behalf Of Florian Anwander
Sent: 25 January 2010 10:14
To: Doepfer_a100@yahoogroups.com
Subject: Re: [Doepfer_a100] DOEPFER at NAMM 2010


  

Hello David

> Assuming that each board is set-up the same is there any reason why 4
> boards can not be wired to single set of controls and sockets?
Only the VCF Cutoff, and the VCO tuning are direct voltage controlled 
parameters. All parameters of envelope, LFO, and all modulation-amounts,

levels mixing potentiometers, switches are direct parts in the circuitry

and cannot be controlled by a CV (which is essential for a single 
controlset).

You might use fourfolded potentiometers, but these are around $20
each...

Or you would build a huge pcb with additional VCAs and CV Switches.

Florian





This email was sent to you by Thomson Reuters, the global news and information company.
Any views expressed in this message are those of the individual sender, except where the sender specifically states them to be the views of Thomson Reuters.



[Non-text portions of this message have been removed]