Digital BW, The Print

Paul,

thank you so much for sharing your work, I've been following your 
expertise for severeal years now over here in the UK, and it's your 
write-up on UT-3D that's got me all fired up again.

What ink configurations are people using with the R1800 - perhaps 
UT7 or a custom mix? (by the way, I'm quite happy using QTR and an X-
Rite Spectro,) I take it that with the R2400, UT-3D works OK?

cheers Paul,

Jamie.

--- In DigitalBlackandWhiteThePrint@yahoogroups.com, "Paul Roark" 
<paul.roark@...> wrote:
>
> Jamie,
> 
> >I'am just about to have a go with the UT-3D inkset 
> >with a few printers and just wanted to check I've got 
> >the basic grasp of things before I start.
> 
> Be sure to check out my write-up at 
> http://home1.gte.net/res09aij/UT-3D_Readme.pdf
> 
> >... when I go to the R1800 and R2400 I will use the 
> > LK and the LLK inks also.
> 
> I have not set up an 1800.  It is such a different printer that I 
doubt the
> UT-3D will work in its current configuration.
> 
> >I haven't seen much conversation regarding the R1800, ...
> 
> There are some people on the forum using it, but not with the 3D 
inkset.
> 
> Good luck with your B&W.
> 
> Paul
> www.PaulRoark.com
>