Digital BW, The Print

I am not an expert but is it possible there is a vent plug you need to
remove?

 

Mike J.

 

 

From: DigitalBlackandWhiteThePrint@yahoogroups.com
[mailto:DigitalBlackandWhiteThePrint@yahoogroups.com] 
Sent: Friday, December 25, 2015 8:33 AM
To: Digital Blackandwhite
Subject: [Digital BW] CIS Question

 

  


After 4 years, my CIS in my 2200 got a bad chip. I just got a new one but
got it empty this time. I filled up the tank and use the syringe to pull ink
into the cartridges. I did not fill the cartridges completely and that could
have been a mistake.

Right now, the printer prints fine but I have 2/3 of the tubes with no ink.

When i print, the ink is pulled slowly toward the cartridges but i am
concerned that i will run out of ink in the cartridges before the ink comes
back and fill them.

If i raise the tanks, the ink flows into the cartridges but when i put them
back down at the printer level, the tubes get emptied again.

Any advice on how to have the tubes with ink going to the cartridges and no
huge gap of air in between

Thanks.

Pierre-Olivier

http://www.DepthofFieldPhotography.com