ComputerVoltageSources

For the .156 MTA connectors, I made an insertion tool from an old 
screwdriver by cutting a slot it in.  It helps to press the wire in.

On the 0.100 MTA connectors, I just use a small screwdriver to press 
the wire in.

Neither of these methods makes a secure connection, it just locates 
the wire.  Then I solder them in place.  I have found that holding the 
connector in a vice sideways (so the connector is horizontal, not 
vertical) works best.  You have to solder quickly.  Too much heat and 
the solder can wick down into the connector.  I've also found that 
tinning the wires prior to insertion really helps.  I've soldered 
probably close to 100 connectors this way and think they are more 
secure than just the press fit.  I know others solder these connectors 
as well.

Dave


--- In ComputerVoltageSources@yahoogroups.com, "Grant Richter" 
<grichter@...> wrote:
>
> I picked up the matching MTA connectors for the CVS. I noticed they 
take a special tool for 
> wire insertion. Does anyone have a simple workaround for the tool or 
is it required?
> 
> Thanks for any tips.
>