ComputerVoltageSources

I pulled my AtomPro28 tonight and replaced it with my spare. I blew
the reset supervisor on this one so thought I would experiment with
it. I'll take it to work tomorrow and let one of the techs remove the
part with the proper equipment. I have a thru-hole xtal that I'll try
soldering on and seeing if I can program the part. I'll update the
group as soon as I have some results.

Dave


--- In ComputerVoltageSources@yahoogroups.com, Dave Manley <dlmanley@
...> wrote:

>
> I've found that applying liquid flux and then adding solder to smt

parts

> will usually get them off pretty quickly. Get the part hot, keep

the

> iron moving between the pads and keep adding solder. Then cleanup

the

> mess with solder wick and finally isopropyl alcohol. I've yet to

damage

> a board doing this. With some of the special tools, it is actually
> easier to damage the board when used incorrectly. A hot-air

desoldering

> tool can scorch a pcb very quickly.
>
> There is also this, a special low temp alloy used to make removing
> soldered parts easier:
>
> http://www.chipquik.com/
>
> I haven't tried it, but it looks very interesting. Unfortunately it

is

> a little bit pricey.
>
> -Dave
>
> >
> > --- In ComputerVoltageSources@yahoogroups.com, "djbrow54"

<davebr@>

> > wrote:
> >> I'm a bit perplexed as to how to get the
> >> resonator off there without specialized SMT desoldering

equipment.

>