On Mar 10, 2006, at 4:49 PM, Grant Richter wrote:
particular), and I believe many of Paul's modules are only about 5"
deep.
Perhaps if you go with the 4 x 6 board, it could be mounted in
shallower MOTM systems with the 4" on top using the two/three-piece
special pot and jack brackets from Stooge Industries, rather than the
stock single piece Stooge brackets.
-Henry
> A 4 x 6 board will fit in a Frac-Rac. Is 6-7 inches too deep forSome MOTM racks only accommodate 5 or so inches (SKB pop-up racks in
> MOTM and Doepfer racks?
particular), and I believe many of Paul's modules are only about 5"
deep.
Perhaps if you go with the 4 x 6 board, it could be mounted in
shallower MOTM systems with the 4" on top using the two/three-piece
special pot and jack brackets from Stooge Industries, rather than the
stock single piece Stooge brackets.
-Henry