AVR-Chat

> >> You stated that '0x51' is the correct divisor, however it should 
be a
> decimal '51' not hex '51' which is what you are setting.
> >> 
> 
> >Not sure what to look at next to figure it out.
> >
> >Brian
> 
> See my comments about '51'.
> 
> Brian (the other one)
OK, I am using a 2.45Mhz xtl, verified buy a digital oscope, remove the 
xtl and the chip doesnt work so I should have my fuses right, and baud 
rate of 9600. My UBRR is set at 10 to get good comms. I am using 16 as 
a divisor, the date sheet says to use 12 as UBRR for 2Mhz. Why am I 
needing a lower number for a little highter freq? Is it ok/common for 
this? I am using a USB to serial to the computer and my STK500.

Brian