The Yamaha AN1x Synthesizer mailing list

I want to modify the settings of my AN1X's pitch bend wheel 
to enable me to pitchbend a sound over a much greater range 
than it will currently allow (which is only one note)

The sound needs to start at a very low freq - perhaps 50-
100Hz? - at the bottom of the wheel's travel, and then be 
pitchbent to a mid-range, piano sort-of frequency at the 
centre wheel setting, then off up into the sonic stratosphere 
at the top of the travel

I sense that it should be easy, but cannot seem to do it - 
either through the front panel or via AN1X Edit.  

Can anyone help?

Thx, C

--- In AN1x-list@y..., christopher john stone <christone@o...> 
wrote:
> 
> I want to modify the settings of my AN1X's pitch bend wheel 
> to enable me to pitchbend a sound over a much greater range 
> than it will currently allow (which is only one note)
> 
> The sound needs to start at a very low freq - perhaps 50-
> 100Hz? - at the bottom of the wheel's travel, and then be 
> pitchbent to a mid-range, piano sort-of frequency at the 
> centre wheel setting, then off up into the sonic stratosphere 
> at the top of the travel
> 
> I sense that it should be easy, but cannot seem to do it - 
> either through the front panel or via AN1X Edit.  
> 
> Can anyone help?
> 
> Thx, C

From the Ctlk Matrix, under VOICE/SCENE SETUP, use the Set 
No parameter to choose Pitch Up and/or Ptich Down then use 
the Depth paramter to set the desired Pitch Bend range. The 
positive and negative amounts can be set independently - the 
range can be adjusted +/- two octaves.

regards,

Jon

Hi C,

On the Matrix page of An1xEdit you can set the Pitch bend range using
the PB UP & PB DOWN knobs. This gives you a maximum range of 48
semitones.

Regards

Gary Gregson

Email:gary@...
http://www.yme.co.uk/yme 

-----Original Message-----
From: christopher john stone [mailto:christone@...] 
Sent: 25 March 2002 14:02
To: AN1x-list@yahoogroups.com
Subject: [AN1x] How do I do this?


I want to modify the settings of my AN1X's pitch bend wheel 
to enable me to pitchbend a sound over a much greater range 
than it will currently allow (which is only one note)

The sound needs to start at a very low freq - perhaps 50-
100Hz? - at the bottom of the wheel's travel, and then be 
pitchbent to a mid-range, piano sort-of frequency at the 
centre wheel setting, then off up into the sonic stratosphere 
at the top of the travel

I sense that it should be easy, but cannot seem to do it - 
either through the front panel or via AN1X Edit.  

Can anyone help?

Thx, C



Community email addresses:
  Post message: AN1x-list@yahoogroups.com
  Subscribe:    AN1x-list-subscribe@yahoogroups.com
  Unsubscribe:  AN1x-list-unsubscribe@yahoogroups.com
  List owner:   AN1x-list-owner@yahoogroups.com

Shortcut URL to this page:
   http://groups.yahoo.com/group/AN1x-list
 

Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/