The Yamaha AN1x Synthesizer mailing list

Hello Ed, Jerry and Gary, I have seen this post and I have a roland EV-5
volume (CV) Pedal, I also have a peavey Midi controller (16 programmable
faders), so I thought I'd see if I could do what you want to do and you
can, very easily.  If you are using VST 5 it would be easy to do as
well.

I checked out the values that XG-edit and AN-edit send for PB and it is
0-127 on both, that makes it simple.  The message you need to send is:

Ex 00 YY


where x= channel 1-16(0-F hex), 00=PB and YY is the value that is sent,
0-F7 hex (0-127)

I hope this helps.



In article <NOENKHDAGJMAKPCEDIELMENCCAAA.gary@...>, Gary Gregson
<gary@...> writes
>Hi Ed/Jerry
>
>Suggested method (1) will be almost impossible to use ...I have never come
>across a pedal that has a centre position (but maybe I haven't been looking
>too hard). Also assigning a controller to VCO1/VCO2 pitch in control Matrix
>is not valid (according to the An1x specs! Although you can directly assign
>the Foot Control to change either VCO1 or VCO2 tune via the system setup)
>
>Method 2 is the only practical way to achieve the result (i.e. assign a
>controller to perform Pitch up or Pitch down)...but as Jerry points out.....
>you can only have unidirectional bend :-(
>
>>>MIDI controller #96 is the default midi controller for pitch bend.
>
>Nope ...#96 is data increment. Pitch bend is not a CC it has its own message
>status type (Ex) and is followed by a 14bit MSB/LSB value.
>
>If you can't live with unidirectional Pitch bend, then the only answer is to
>use some external software to map your foot controller to pitch bend
>messages.
>
>Regarding Jerry's question about configuring the controller change mode of
>the An1x...refer to page 96 of the manual. Basically turn off the power,
>then power on whilst holding ASSIGN. The LCD should show the mode being
>activated (i.e. mode 1 or mode2).
>
>Regards
>
>Gary
>Email:
>     gary@...
>     http://www.yme.co.uk/yme
>
>
>
>Community email addresses:
>  Post message: AN1x-list@yahoogroups.com
>  Subscribe:    AN1x-list-subscribe@yahoogroups.com
>  Unsubscribe:  AN1x-list-unsubscribe@yahoogroups.com
>  List owner:   AN1x-list-owner@yahoogroups.com
>
>Shortcut URL to this page:
>   http://groups.yahoo.com/group/AN1x-list
> 
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ 
>
>

See ya,

Reggie