The Yamaha AN1x Synthesizer mailing list

Hello Dave !
i think that your problems are there :

> Can someone advise if this is in fact stoopid and if so 
>how to connect properly to my interface.
>
Yes, because both channels are not mixed properly . If you need only a 
mono signal to plug in your sound card or mixer you must use the "L- 
mono" output only with a mono cable . Don't plug anything in the other 
line output (A.K.A. "Right"). Using a mono sound as this you cannot have 
all the stereo based effect like dynamic panning. But it will sound 
correctly . I've tried it in a guitar amp (mono, of course) and the 
sound was OK. Not very good because the frequency range of a guitar is 
narrower than a synthesizer and the guitar amps are designed 
for....guitars. But it worked ; in fact it was to test the auxiliary 
input of the amp...
Cheers
J.F.

schmaltzberger a \ufffdcrit :

>Hi there,
>Dave from Australia here, new to the an1x but loving fooling around 
>with it. I have been using software synths in Logic Pro for the last 
>couple of years and decided to take the plunge into a hardware synth. 
>This is where I get stoopid. 
>My problem is that I can't hear some of the voices (particularly bass 
>voices) on the an1x. Also when i intitialise a voice using "template 
>1,2,3,7 & 8 I can't hear the initial waveform to begin customising 
>the sound. I can hear the waveform fine on 4,5 and 6 "template".Well 
>I can hear it but only if I really crank the interface which also 
>produces a lot of noise. 
>I suspect this maybe where I am going wrong.. I have the an1x plugged 
>into a single channel on my tascam fw1804 interface. I have a stereo 
>out cable that goes from the synth to a single input to plug into my 
>interface. Can someone advise if this is in fact stoopid and if so 
>how to connect properly to my interface. Secondly could this explain 
>the apparent lack of volume on some voices and initialised waveforms?
>Despite my stoopidity I am loving the sounds of this thing. Special 
>appreciation to the creator of the logic environments..now I just 
>need to work out how to use them.
>thanks,
>Dave
>
>
>  
>