The Yamaha AN1x Synthesizer mailing list

Hello,

all u really need is to look at page 9 of the Data list manual 
and make sure that your AN1X is in mode 2 
and NOT in mode 1 

(at page 96 of the Owner's manual how to do it) 


My personal fav would be 

VCF cutoff     VCF res     Vca A         Vca D    Vca S     Vca R 

Lfo1 speed    Lfo2 speed   Vco Fmdepth   Rev      Chor      Delay 


but it always depends on a specific patch, a generic setup like this 
can not always be useful but a good starting point 

Regards
--------------------------------------------------Env1-----Env2--Env3-----------
Andrea.TONI@...                          Vco1 \    |     |  \
Solar System Missions (Sci-Sm)                    Vco2-->--Vcf-->Vca-->Ducati996 
www.rssd.esa.int                                  Vco3 /    |     |  /
--------------------------------------------------Lfo1-----Lfo2--Lfo3-----------

   From: "fai31188" <fai31188@...>
Subject: Assignable Knobs

Hello everyone. I am enjoying my board, but, can't say I am using it
to its fullest potential. I was turning knobs yesterday and realized
that I don't have my 8 assignable knobs assigned to anything. I know
this may be a ridiculous question, but, I am looking for suggestions
for assigning parameters to these knobs. I am a noob when it comes to
synthesis, so, parameters that would change the sound of the patch in
real time would be ideal!!