Archive of the former Yahoo!Groups mailing list: Korg Poly800/EX800 Users
Subject: Re: HELP! power supply causing pcb short
From: "Dennis" <dennisweathers@...>
Date: 2008-08-26
yes it's tip positive.
--- In korgpolyex@yahoogroups.com, Marcus Wilson <JB@...> wrote:
>
> check the polarity of the power plug, it must be tip positive
>
> if its tip negative, it will disconnect power from the battery and
> apply inverted voltage to the input, theres a zener in there to offer
> some protection so you
> dont fry everything, but its not a good thing to keep juiced up with
> incorrect polarity
>
> best regards,
>
> Marcus Wilson
>
>
> On 25/08/2008, at 6:16 PM, Dennis wrote:
>
> > This poly 800 seems to function just fine on batteries but when a 9
> > vdc converter is plugged in it goes dead. I figured it was the jack
> > and replaced it after desoldering the original and replacing it with a
> > clone. Same problem. Any ideas would be greatly appreciated!
> >
> > Thanks!
> >
> >
> >
>