Archive of the former Yahoo!Groups mailing list: Korg Poly800/EX800 Users

Hi,i didn't made Moog Slayer Mod,but I replaced  trimmers on board to similar ( 100k & 10k ) on front panel ,but deph of CUTOFF & RESONANCE regulation depends of  tuning "41" & "42" parameters of POLY800. I use it & it works very good.                                                                                           
Best regards.Alexandro.
Dave Bowman <davidmochen@...> пишет:

my solution wouldnt apply to you cos you unfortunately ruined your
trimmer pots...

instead of using fixed 100k (for cutoff) and 10k (for reso) resistors
(these are the values of the trimmers when set to full resistance,
sorry about the terminology, not an expert here) i kept the same
trimmers and used them so i could retain the original factory sound...

i dunno at this point if its any use to go for 100k and 10 k. i
guess the sound wold be real dull. maybe olaf can shed some light on
this.

dave


--- In korgpolyex@yahoogroups.com, "mahceenaleen" <kaneelisdead@...>
wrote:
>
> Now that i got back internet at home, i can spend some time
explaining
> the tiny problem i just got while doing this mod:
> http://launch.ph.groups.yahoo.com/group/korgpolyex/photos/browse/52
a
3
>
> as you can say, it's asked to remove the two trimmer pots and to
> replace them by resistors of the very same values... my problem is
> that i'm not sure about which values you're talking about, the
value
> written on the side of the trim pots? or the value you have to
check
> using a ohm-meter?
> Coz the problem is here, i suck at desoldering even more than at
> soldering, so i kind of "ruined" the trim pots :/
>
> Any help would be welcomed!
>
> thx!
>

Вы уже с Yahoo!? Испытайте обновленную и улучшенную Yahoo! Почту!
http://ru.mail.yahoo.com